Page 27 of 88
User Guide
Petwalk Solutions GmbH & Co KG
11.
Now insert the tunnel plates, which were previously cut to the appropriate length and fitted
with sealing tape into the groove provided in the device. Press the plates against slight
resistance of the seals completely into the groove and then draw them out again carefully
for approximately 5mm.
WARNING!
When pushing the upper tunnel plate into the notch please make
sure that the connection cable is placed on top of the tunnel
plate and is not crushed by the tunnel plate. In the middle of
the upper notch you can find an additional slot for the
protection of the cable. The cable must be routed to the top via
this slot.
TIPP!
Sticking the tunnel plates together with adhesive tape the body
of the tunnel will gain stability. Consequently the insertion of
the outer flange plus tunnel into the aperture of the wall is
substantially simplified. For tunnel lengths of more than 50cm it
is advisable to fix even the threaded rods to the tunnel body
with adhesive tape.
