Page 55 of 88
User Guide
Petwalk Solutions GmbH & Co KG
10.2.7
BASIC RFID SETTINGS
You can set the RFID operation to be active for both sides or only for either the outside or the
inside. If RFID is disabled the door will operate on standard movement detection mode for this
particular side. By default the petWALK animal door is set to use RFID control for both sides if
access control
is activated.
If you want to change the default settings, quickly press the
Setup
button twice. The
display looks like this.
Now press the
Up
and
Down
buttons until
rFid
is shown on the display:
With the
OK
button you access RFID configuration. The display shows
run
:
The symbols for
Exit Control
and Entrance Control
will blink green, indicating that
activated access control will work in both directions (Default configuration)
In pressing the key
Access
Control
you can disable RFID access control for any direction. A
blinking red light means that for this side access control is disabled, a green flashing light means
it is activated.
In this example it means that RFID control will be only active for the outside once
Access
Control
is activated. On the inside the door will operate on movement control.
NOTE!
This mode is also useful if there is a risk that a foreign animal
might unintentionally follow your pet into the house. That way
this animal may leave the house again.
