Petwalk Solutions GmbH & Co KG
User Guide
Page 50 of 88
Petwalk Solutions GmbH & Co KG
User Guide
Page 50 of 88
Press the
OK
button
to save the new time setting confirmed by a beep tone. The display
will return (as shown above) to the setting mode.
You leave the setting mode by pressing the
OK
button
, or by pressing the
Setup
button
or by pressing the
Operating Mode
button
.
You can cancel the time setting at any time without saving the new value. You do this by
pressing the
Setup
button
.
10.2.2
SETTING OF OPENING TIME
The petWALK pet door also offers you the option to set the opening times according to your
needs. As long as the pet door detects motion in its environment, it will not close. Thus, the
safety of your pet is always guaranteed.
The opening time is defined as the time period between the last detected movement and the
door starting to close. So you can determine the best compromise between comfortable passage
time for your pet and the least possible loss of energy in the house.
To adjust the opening time of the petWALK pet door, press the
Setup
button
. The green
flash in the display indicates that the controller is in setup mode.
Press the
Manual door opener button
. The display shows:
The image 02 on the display shows you the opening time in seconds after the last motion was
detected. You can vary this value by using the
Up
button and
Down
button from 2 to 99.
Use the
OK
button to save this value and it automatically takes you to the menu for setting
the
range of the motion sensor
, which will be explained in the corresponding chapter. For now,
you confirm with the
OK
button for several times until you get back to the setting (display
blinks green).
You leave this setting by pressing the
OK
button or by pressing the
Setup
button or by
pressing the
Operating Mode
button.
