PerkinElmer Lambda 1050, Hardware Manual

Page: 47 / 82

Installing your Lambda Spectrometer . 47
Installing Accessories
WARNING
Electrical Hazard
To prevent potential injury to yourself and damage to the instrument,
switch OFF all instruments in the system and disconnect them from the
line power supply before you alter any, or make any new, electrical
connections.
NOTE: To operate the spectrometer with some accessories, for example Peltier cell
changers, you need an accessory printed circuit board (PCB) fitted in the connector
panel. The accessory PCB will be installed by a PerkinElmer Service Engineer.
This section of the manual details changes that may need to be made to the basic
spectrometer before installing an accessory, and gives an overview of the installation
required for some of the specific accessories. Full procedures for installing the accessories in
the spectrometer are described in the documentation provided with the respective
accessories.
Removing the Parts of the Sample Compartment
Removing the Sample Compartment Cover
1. Open the sample compartment cover so that the lid is at 90 degrees.
2. Push back on the base of the lid to release the three lugs holding it in place.
Figure 15 Opening the sample compartment to reveal the three lugs
3. Lift the whole lid vertically to remove.
NOTE: To refit the lid, make sure that the lugs are properly inserted into the holes, and then
holding the lid vertically, pull it towards the front the instrument making sure that the
lugs are fully locked into place.