40
RCS-2 Climbing Device and Hydraulics
Assembly Instructions
D4 Climbing procedure
■
A detailed description of the climbing
procedure can be found in the Instruc-
tions for Assembly and Use for the
climbing system.
■
Observe the assembly instructions for
the hydraulic pump.
Observe the project-specific climbing pro-
cedure diagram and hydraulic connection
diagram.
Set the hydraulic pump so it is ready
for operation
1. Check that all climbing groups are col-
lated correctly.
2. Check that all pumps are in the correct
operating mode.
3. Press the “Status/Reset” (
3.19
) button
on all hydraulic pumps until all buttons
go green, and correct and acknowledge
any errors that occur.
→
The pumps are ready for operation.
(Fig. D4.03)
Extend climbing device
1. Press the “Cylinder Extend” button
(
13.1
) on the remote control.
→
The climbing device extends.
(Fig. D4.04)
If multiple remote controls are connected,
they must all be activated simultaneously,
otherwise the climbing system will not
move.
3.19
Fig. D4.03
Fig. D4.04
13.1
Summary of Contents for MO-20-00445 0
Page 61: ...61 RCS 2 Climbing Device and Hydraulics Assembly Instructions ...
Page 79: ......
