Peri MO-20-00445 0, Assembly, Commissioning And Maintenance Instructions

Page: 13 / 80

13
RCS-2 Climbing Device and Hydraulics
Assembly Instructions
Introduction
Protection from falling objects
Secure tools and material from falling
down. Remove concrete residue and oth-
er dirt.
Avoid installing working areas and access
routes in areas of risk. If this is not possi-
ble due to work procedures, suitable
equipment (e.g. protective roofs) must be
available to provide protection against fall-
ing objects. This also applies to work that
only takes a short period of time.
Operational working areas at great
heights are to be secured by means of ap-
propriate structural measures to prevent
objects from falling down. Safety nets
(mesh size ≤ 2 cm) and platform planking
are considered to be suitable means and
are to be installed very close to the struc-
ture (distance ≤ 5 cm).
Assembly
Unexpected hazards can always arise
when assembly work is carried out. As-
sess the degree of risk in each individual
case and, if necessary, take measures to
prevent or at least minimise the risk.
If guardrails cannot be used due to techni-
cal reasons or have to be removed, site
personnel should be safeguarded by other
means (e.g. through rope protection).
Site personnel are not permitted to loiter
beneath areas where assembly work is
being carried out, unless the area of risk
has been provided with sufficient protec-
tion against falling, overturned, sliding or
rolling objects and masses. Areas of risk
must be cordoned off.
Crushing risk!
Do not touch if the load is moving!