Pegasolift PL13, Maintenance & User'S Manual

Page: 165 / 180

B 57
56
1
4
2
TILLER HEAD
1) Button against the collision: in the
case of incidental collision blocks
the stacker and pushes it for a
short forward movement.
2) Butterfly control buttons for
movement and speed.
3) Horn.
4) Button for the lifting: puts into
function the pump sending
pressure in the oleodynamic
cylinders allowing so to lift the load.
INSTRUMENTS AND TILLER HEAD
INSTRUMENTS:
1) Switch for the battery disconnection: allows to disconnect the electronic part of the
desk of the battery; push on for disconnecting; turn it in the sense of watch needles
until it starts.
2) Battery charge indicator: displays, with illuminated LED elements, the load situation
of the battery.
Instruments
2
1
57
PUTTING IN FUNCTION AND STACKER UTILISATION
PRELIMINARY CONTROLS:
The stacker ready to use must be in the following conditions:
1) Battery loading tap: disconnected.
2) Start contact: deactivated with the key taken out.
3) Switch for disconnecting the battery: connected.
4) Tiller bar: in vertical position
5) Lifting group: completely lowered.
LIFTING AND LOWERING OPERATIONS
1) Introduce the forks in the lower part of the pallet on which the load is put with
maximum of care and minimum speed; it is recommended for a bigger stability of
the load to introduce completely the forks (see page 12 “Transport of load”).
2) Control that the load is equally distributed on the forks and the positions of the
barycenter is within the limits shown by the arrow on the stacker.
3) For lifting: keep pushing the button for lifting (reference page 17 “Tiller head” no. 6)
until the desired height is achieved.
4) For lowering: keep pushing the button for descent (reference page 17 “Tiller head”
no. 4) until the desired height is achieved.
Forward running Backwards running
Fig. B
B
R
B
B = active brake
R = running
FORWARD AND REVERSE MOVEMENT OPERATIONS:
1) Introduce the start key.
2) Push simultaneously
with both hands the tiller
head and bring it in a quite
horizontal position: the
positions completely
horizontal and vertical
forbid the forward and
reverse movement (figure
B).
3) Operate the butterfly
control buttons for movement: turning in the
sense of watch needles the stacker moves
forward, in the contrary sense the stacker
moves reverse.
Controlling in an adequate manner the
turning there it is easy to control the stacker
speed.
It is advised to avoid abrupt and repeated
starts and slowing down in order to avoid
overheating of the motor and rapid
discharge of the battery.
ATTENTION!
The load lifting and lowering operations should be
executed only with the stacker completely stopped.