PATON
ProMIG
DC MMA/TIG/MIG/MAG
- 42 -
8. SUPPLY FROM POWER GENERATORS
The power supply is suitable for operation on a generator under the following conditions:
During electrode
operation
Set current value for
MMA and TIG
During welding wire operation
Minimum generator
power
Ø2
not more than 80А
not more than Ø0.6мм
3,0 kVA
Ø3
not more than 120A
not more than Ø0.8мм
4,5 kVA
Ø4
not more than 160A
not more than Ø1.0мм
6,0 kVA
Ø5
not more than 200A
not more than Ø1.0мм
7,7 kVA
Ø6 fusible
not more than 250A
not more than Ø1.2мм
10,0 kVA
Ø6 fusible
not more than 270A
not more than Ø1.2мм
12,0 kVA
Ø6
not more than 350А
not more than Ø1.4мм
16,0 kVA
Ø8 fusible
not more than 500А
not more than Ø1.6мм
30,5 kVA
Ø8
up to 630А
not more than Ø2.0мм
42,0 kVA
ATTENTION!:
For smooth operation, the output voltage of the generator must not exceed
the permissible limits:
-
160-260V (for ProMIG-160/200/250);
-
320-440V for all three phases (for ProMIG-270/350/500/630).
The power source can be supplied by various types of generators. However, some of these
may not provide sufficient power for proper operation of the welding current source.
Gensets with automatic voltage regulation (AVR) or an equivalent or better type of
regulation, with the power rating specified in the operating manual.
9. SERVICE AND MAINTENANCE
ATTENTION:
Before opening the device, switch it off, remove the plug from the socket.
Wait (about 5 minutes) for the device's internal electrical circuits to discharge, and only then
carry out the remaining operations. If you walk away from the device, it is advisable to place
a plate indicating that the device should not be switched on.
To keep your device in good condition for years to come, follow the recommendations:
-
Perform safety checks at specified intervals (see section "Safety rules");
-
In the event of intensive use, it is recommended to clean the unit every six months
with compressed air.
ATTENTION!:
Blowing from too close a distance may damage
electronic components;
-
If there is a lot of dust, manual cleaning of the cooling system ducts is
recommended.
Summary of Contents for PROMIG-160
Page 1: ...j...
