- 23 -
PATON
ProMIG
DC MMA/TIG/MIG/MAG
Operating procedure:
-
set the device's main power switch 12 on the rear panel to the "ON" position;
-
use button 4 to set the TIG welding mode (functions are switched over and over);
-
set the function of the TIG-LIFT torch button. To do this, hold down button 3 until
"Torch button" [But] appears on the indicator; the current position of this function
will also be displayed next to it. Use buttons 2 to set "LIFT". If you do not take any
action for a long time, the device will leave this function. You can return in the same
way, and if you have skipped the required button mode, press button 3 again
(functions are switched over and over);
-
using the 2 buttons, the current main parameter, i.e. the welding current, can be
set;
If necessary, additional welding process functions can be set (see Section 6.1 for the switching sequence).
4.1.3 WELDING PROCESS CYCLE - TIG-2T
The procedure for switching the value of any function is described in section 6.1.
For this mode, it will be necessary to purchase a separate non-contact arc ignition unit
(oscillator). The procedure for preparing the unit for use with an oscillator is individual and
should be described in the accompanying instruction manual. The source control connector
is located on the rear panel of the source. Only use pins 1 and 2, DO NOT mix them with
other pins - this may lead to unit failure!
ATTENTION!
If this connector is not in use, it should be covered with a protective rubber
cap to keep out pollution.
Summary of Contents for PROMIG-160
Page 1: ...j...
