PATON
ProMIG
DC MMA/TIG/MIG/MAG
- 16 -
Procedure for preparing the unit for operation:
-
This welding mode does not require a wire feeder, so it can be detached;
-
insert the electrode holder cable into the socket of the source A “+”;
-
insert the ground clamp into the socket of the source B “
-
”;
-
connect the "ground" clamp to the workpiece;
-
connect the mains cable to the three-phase mains (for ProMIG-270/350/500/630
models);
-
set the device's main power switch 12 on the rear panel to the "ON" position;
-
use button 4 to set the MMA welding mode, the modes are switched in a circle;
-
use button 2 to set the main current parameter, i.e. the welding current;
If necessary, additional welding process functions can be set, see Section 6.1 for the switching sequence.
ATTENTION!
After the power switch (12) has been switched to the "ON" position, the
covered electrode is under voltage. Do not touch the electrode to conductive objects or
earthed objects such as, for example, the unit housing, etc. as the device will perceive this
condition as a signal to start the welding process.
3.1 WELDING PROCESS CYCLE
– SMAW
The procedure for switching the value of any function is described in section 6.1.
Summary of Contents for PROMIG-160
Page 1: ...j...