POLARES 32
35
Errore. Per applicare Heading 1 al testo da visualizzare in questo punto, utilizzare la scheda
Home.
•
The Measurements window contains commands for selecting and carrying out
measurements, in particular an additional column in the measurements table for selecting
the measurements to be performed using a checkbox associated with each measurement.
•
There are more columns in the Measurements table than in the template window.
These columns relate to the measured data for each measurement, a list of which is given
in section 4.3.4.
•
The “Graph” button replaces the “Go to Measurement Session” button. The use
of this button is explained in section 4.3.5.
•
The “Save Session” button replaces the “Save Template” button; its function is
described in section 4.3.6.
Editing the parameters
Most of the parameters set in the template are fixed for the measurement session derived
from it, and are therefore displayed on the session pages in read-only mode. However,
some parameters may be edited, as the measurement conditions may be different from
how they were designed. The parameter that can be edited in the Electrical parameters
window is as follows.
•
Frequency value used for the measurement. As this parameter affects the
measured value, the frequency value configured at Template level is reported and used
for each measurement, and is displayed in the measurement table, but can be changed
during measurement execution. This means that a measurement session can be performed
using different frequency parameter values for different measurements.
Testing the electrodes
The electrode test function is located within the electrode parameter display window and
allows the user to check the correct functioning of the electrodes and their connections.
