MSG11-5715-743/EN: AC20F Series - Hardware Installation Manual
MSG11-5715-743/EN 24.04.2023
95 (148)
9.2
‘Remote’ Operation (Using Pre-Defined Macro’s)
To run the drive ‘remotely’ (using either push-buttons, switches or PLC’s as opposed to a keypad), the
following steps need to be followed.
Note: This sequence assumes that the
‘Basic Drive Setup’ routine has been completed, as outlined
above.
Enable ‘Remote’ Control Mode
To enable ‘
Remote
’ Control Mode:
Remote Control Mode Selection
Onboard Keypad Display
6901 Remote Keypad Display
Press and hold the ‘
Stop
’ key for approx. 3
seconds as “
LOCAL
… TO … REMOTE
” appears
across the display.
Press the
‘
L/R
’ key.
Once ‘
Remote
’ Control Mode is enabled, the drive will show the following status indication:
Remote Control Mode ‘Enabled’
Onboard Keypad Display
6901 Remote Keypad Display
No indication displayed.
The ‘
SEQ
’ & ‘
REF
’ LEDs will turn off.
Running The Drive
Providing the drive is:
1.
Set to ‘
Remote
’ operating mode.
2.
‘
Initial Drive Setup
’ has been completed.
3.
An ‘
Autotune
’ routine has been completed (if set to SVC mode).
The drive is ready to be run from the remote switches (see application examples below):
