Paradyne COMSPHERE 3610, Operator'S Manual

Page: 222 / 310

COMSPHERE 3600 Series Data Service Units
C-20 July 1999 3610-A2-GB91-90
Table C-10
(7 of 8)
TDM/MCMP/Bridge Configuration Error Messages
Message Action Condition
Prts >2: FEP Chan MCMP mode: A channel assigned to
both ports of an FEP port-sharing
group is also assigned to one or more
other ports.
Upon assigning a channel to an FEP
port-sharing group, the channel
cannot be assigned to a port outside
of the FEP port-sharing group.
Assign the channel only to the two
ports of the FEP port-sharing group
via the Chan path in the PrtSp
configuration submenu.
RTS/AnStr Conflc TDM, MCMP, or Bridge mode:
A port’s antistreaming and RTS
Control settings are not compatible.
For antistreaming to be in effect, RTS
Control must be set to DTE.
Set configuration option RTS Control
to DTE via the appropriate path
(Prt1—Prt6) in the MUX configuration
submenu.
RTS/TxCrr Conflc TDM, MCMP, or Bridge mode:
A port’s TxCarrSel (Transmitter
Carrier Select) and RTS Cntrl (RTS
Control) settings are not compatible.
When a port’s TxCarrSel is set to
Cntrl, its RTS Cntrl must be set to
DTE. When a port’s TxCarrSel is set
to Const, its RTS Cntrl must be set to
FrcOn.
Set configuration options Transmitter
Carrier Select (TxCarrSel) and RTS
Control (RTS Cntrl) to compatible
settings via the appropriate path
(Prt1—Prt6) in the MUX configuration
submenu.
Spd Not=forChan MCMP mode: A channel is assigned
to two or more ports and the ports are
not all operating at the same speed.
All ports receiving the same channel
assignment must be operating at the
same speed.
Configure all ports receiving the same
channel assignment to one speed via
the DSU path in the PrtSp
configuration submenu.
Sync >Async Req TDM mode: The asynchronous rate
setting for the port requires that more
capacity (bandwidth) be allocated to
the port.
Asynchronous rates of 150, 300, 600,
and 1200 bps require the allocation of
1200 bps — exception: at a line
speed of 56 or 64 kbps,
asynchronous rates 150, 300, 600,
and 1200 bps require the allocation of
2400 bps. Asynchronous rate of 1800
bps requires the allocation of
2400 bps.
For all other available asynchronous
rates, asynchronous rate equals
synchronous rate.
Allocate more capacity to the port by
setting the port to a higher speed via
the appropriate path (DSU or DBM) in
the PrtSp configuration submenu.