Paradigm SOUNDPLAY, Owner'S Manual

Page: 3 / 72

2
products that are not in use for extended periods
of time. Store batteries in a dry place.
32. Do not recharge non-rechargeable batteries.
33. Avoid exposure to extreme heat or cold.
34. This equipment is a Class II or double
insulated electrical appliance. It has been
designed in such a way that it does not
require a safety connection to electrical earth.
35. Danger of explosion if battery is incorrectly
replaced. Replace only with the same or
equivalent type.
36. (The remote control supplied with) This product
contains a AAA battery. If the AAA battery is
swallowed, it can cause severe internal burns in
just
2 hours and can lead to death.
37. Do not handle leaking or damaged AAA batteries.
38. THIS PRODUCT CONTAINS A AAA BATTERY. IF
MISUSED OR ABUSED THIS CAN RESULT IN:
- Smoke or gas hazard
- Heat hazard
- Fire hazard
- Explosion hazard
WARNING: This product is intended to be operated
ONLY from the AC Voltages listed on the back panel
or included power supply of the product. Operation
from other voltages other than those indicated may
cause irreversible damage to the product and void
the product warranty. The use of AC Plug Adapters
is cautioned because it can allow the product to be
plugged into voltages in which the product was not
designed to operate. If the product is equipped with a
detachable power cord, use only the type provided with
your product or by your local distributor and/or retailer.
If you are unsure of the correct operational voltage,
please contact your local distributor and/or retailer.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) This device may not cause harmful interference, and
(2) this device must accept any interference received,
including interference that may cause
undesired operation.
FEDERAL COMMUNICATIONS COMMISSION
INTERFERENCE STATEMENT: This equipment has
been tested and found to comply with the limits for a
Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable
protection against harmful interference in a residential
installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed
and used in accordance with the instructions, may
cause harmful interference to radio communications.
However, there is no guarantee that interference will
not occur in a particular installation. If this equipment
does cause harmful interference to radio or television
reception, which can be determined by turning the
equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment
and receiver.
• Connect the equipment into an outlet on a circuit
different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio/TV
technician for help.
Approved under the verification provision of FCC Part
15 as a Class B Digital Device.
Any changes or modifications not expressly approved
by the grantee of this device could void the user’s
authority to operate the equipment.
RF EXPOSURE INFORMATION: This equipment
complies with FCC/IC radiation exposure limits set
forth for an uncontrolled environment and meets
the FCC radio frequency (RF) Exposure Guidelines in
Supplement C to OET65 and RSS-102 of the IC radio
frequency (RF) Exposure rules. This equipment has
very low levels of
RF energy that are deemed to comply without testing of
specific absorption ratio (SAR).
CANADA, INDUSTRY CANADA (IC) NOTICES: This Class
B digital apparatus complies with Canadian ICES-003
and RSS-210. Operation is subject to the following two
conditions: (1) this device may not cause interference,
and (2) this device must accept any interference,
including interference that may cause undesired
operation of the device.
RADIO FREQUENCY (RF) EXPOSURE INFORMATION:
This equipment complies with FCC/IC radiation
exposure limits set forth for an uncontrolled
environment and meets the FCC radio frequency
(RF) Exposure Guidelines in Supplement C to OET65
and RSS-102 of the IC radio frequency (RF) Exposure
rules. This equipment has very low levels of RF energy
that are deemed to comply without testing of specific
absorption ratio (SAR).
2. CAUTION
• Comply with FCC RF exposure compliance
requirement, separation distance of at least 20 cm
must be maintained between this product and all
persons.
• This product and its antenna must not be
co-located or operating in conjunction with any
other antenna or transmitter.
• This transmitter must not be co-located or
operating in conjunction with any other antenna or
transmitter.
• This device meets all the other requirements
specified in Part 15E, Section 15.407 of the FCC
Rules.
This product complies with Part 15 of the FCC Rules.
Operation is subject to the following two conditions:
(1) this product may not cause harmful interference,
and
(2) this product must accept any interference received,
including interference that may cause undesired
operation.
Paradigm Electronics Inc.
205 Annagem Blvd. Mississauga, ON L5T 2V1