23
The learning function of the soundbar allows
you to program either scenario.
Learn Remote: Enter the submenu by press-
ing the enter button. The settings in this menu
program the soundbar to respond to a second
remote control. The factory supplied remote
control will always work with the soundbar,
even if the soundbar is programmed to respond
to a second remote.
Using the up/down directional buttons, you can
select and program the following commands:
•
• Volume –
• Mute
• Next Input
• Previous Input
• Up
• Down
• Left
• Right
• Enter
• Bass Mode: Night
• Bass Mode: Normal
• Bass Mode: Bass+
• Stereo Mode: Wide
• Stereo Mode: Voice+
• Stereo Mode: Normal
• Power Toggle
• Power On
• Power Off
• Menu
• Input: Bluetooth
• Input: Optical 1
• Input: Optical 2
• Input: Analog 1
• Input: Analog 2
• ARC On [Anthem Room Correction On]
• ARC Off [Anthem Room Correction Off]
Choose the command you want to program
and press the enter button. The soundbar will
respond with ‘Push Button’. Hold the second
remote approximately 12 inches (30cm) from
the soundbar and press the appropriate but-
ton four times. If the new command is learned
successfully, the soundbar’s display will display
“Saved”. If the new command is not learned,
the soundbar will display “Failed”. Repeat the
process if learning fails.
Learn > Reset Remote: Enter the submenu by
pressing the enter button. Erasing will clear
programming for the second remote. The Reset
function requires confirmation.
Learn > Reset Remote > No: Activate by press-
ing the enter button. Choosing this option will
exit without erasing the remote programming.
Learn > Reset Remote >Yes: Activate by press-
ing the enter button. The soundbar will respond
with ‘Resetting’. After codes are reset, there is
no way to recover the previous settings.
MENU OPTION: SOURCE NAME
Source Name: Enter the submenu by pressing
the enter button. The settings in this menu will
allow you to assign new names to display
on the soundbar when changing inputs. For
example, you can program the ‘Optical 1’ input
to display ‘DVD’. Using the up/down directional
buttons, you can select and program the fol-
lowing input names:
• Optical 1
• Optical 2
• Analog 1
• Analog 2
Choose the input name you want to reprogram
and press the enter button. The soundbar
display will display the current name.
Pressing the up/down directional buttons will
cycle through the available alpha-numeric
characters. Pressing the left/right directional
Summary of Contents for SOUNDPLAY
