Instruction Manual ECO LIFT
Page 12 of 32
Version 2.03
Subsequently - as described in the illustration shown below - the enclosed snap ring, the
washer (small) as well as the sleeve must be slid onto the screw in this sequence. Following
this, the screw with washers is inserted from below and the large washer placed on top.
The castor can now be mounted at the respective points where the adjustable rubber legs
were previously unscrewed using the enclosed Allen key (see picture documentation
below). Please be careful not to overtighten the screws, as otherwise the screws or the table
may be damaged.
Make sure that the order of materials is correctly adhered to, as this could result in
damage, excessive wear and tear, as well as instability of the table.
Attention:
In this context, please also note that the castors specified above can be easily
purchased after the initial sale and subsequently mounted on your existing
table.
Mounting at
the product
Mounting at
the product
Tighten by using
Allen Key
