BA_PH_BSB-400-900_EN_44-21.docx
32
9.4
Adjusting the upper Bandsaw Wheel
The wheel adjustment controls are located at the top of the rear of the machine (see
By turning the bandsaw wheel by hand, the position of the blade can be checked.
On machines without an electronic motor brake, the brake release switch must be turned to
"active" before turning the bandsaw wheel by hand.
Adjustment of the wheel may only be carried out by trained personnel!
The star knob (
12
) is used to adjust the inclination of the upper bandsaw
wheel. This allows the position of the blade on the bandsaw wheel to be
determined. Clamping lever (
13
) is used to clamp the star knob (
12
).
The blade must run on the bandsaw wheels as follows:
•
Narrow bandsaw blade
→
In the middle of the wheels
•
Wide bandsaw blade
→
Teeth at the edge of the wheels, but
not protruding beyond them.
Figure 26: Bandsaw wheel adjustment
9.5
Height adjustment of the upper Saw Blade Guide
The height should be set for material processing so that the guide rollers of the saw blade
guide are a maximum of 4 - 5 mm above the workpiece.
The height adjustment of the upper saw blade guide (incl. saw blade
guard) is done via the 3-arm lever
7
(
3a
) and the star knob (
3b
), which
is used only for clamping.
Adjust height:
•
First loosen the clamp with the star knob (
3b
).
•
Turn the 3-arm lever (
3a
) to the left
↺
→
move upwards.
•
Turn the 3-arm lever (
3a
) to the right
↻
→
move downwards.
•
After adjustment, clamp again with star knob (
3b
).
Figure 27: Lever for height adjustment
9.6
Swivel Table
Bandsaws of the BSB series have a swivelling table plate as standard, which can be tilted up to 45°. Clamping
lever and angle scale are located on the rear side of the machine under the table.
Figure 28: Adjust table inclination
Adjust table inclination:
•
Remove workpieces and workpiece-remains from the table.
•
Position the fence to the right of the saw blade and fasten it.
•
Release the clamping with lever (
H
).
•
Tilt the table to the desired angle by hand.
•
The angle can be read off the scale (
S
).
•
Then clamp the table again with the lever (
H
).
Note:
Optionally, a table swivelling device is available, which can
be adjusted via a hand crank (for more details see section
7
The model BSB 400 has a handwheel instead of the 3-arm lever.
12
13
3a
3b
H
S
