BA_PH_BSB-400-900_EN_44-21.docx
40
13
Optional Components
The available optional components and accessories vary according to the bandsaw model. Please refer to the
tables in chapter
17 to see which options and accessories are available for your machine.
13.1
Variable Sawblade Speed Control
Figure 39: Blade speed control
Bandsaws equipped with this option have a special control panel with an
additional potentiometer for speed adjustment from approx. 300 to 2000
m/min (varies depending on the model). The actual speed is visualised on a
small display in the control panel.
•
The potentiometer is used to set the speed
•
The speed is visualised in the small digital display
•
The red lamp signals faults in the frequency inverter
For further information see section
Art. No. and further accessories see chapter
Note:
The control lamp
“
Fault
”
lights up in the event of a fault on the frequency inverter. If this occurs, please
contact our customer service.
Danger from electric shock at the frequency inverter! After switching off the main switch
wait at least 15 minutes before working on the unit!
Models with this option are additionally equipped with a wear-free, electric motor brake.
13.2
Measurement Scale on the Table
Figure 40: Measurement scale on the table
The optional measurement scale on the table makes working on
the bandsaw easy and simple. The fence can be set exactly to the
desired cutting dimension without the need for additional meas-
uring equipment. The scale is firmly integrated in the machine ta-
ble and its robustness ensures a long service life.
Art. No. and further accessories see chapter
13.3
Table Swivel Device
The optional table swivel device is a useful addition, especially for heavy machine tables. Instead of swivelling
the table by hand, this option allows to adjust it comfortably and infinitely variable via a hand crank. The adjust-
ment range allows angles up to 45°.
Figure 41: Adjust the table Inclination
Adjust the Table Inclination:
•
Remove workpieces and workpiece-remains from the table.
•
Place the fence to the right of the saw blade and clamp it.
•
Release clamping with lever (
H
)
•
Turn the crank handle (
K
) and read the angle scale (
S
) to set
the desired position.
•
Clamp the table again with the lever (
H
).
Art. No. and further accessories see chapter
H
S
K
