PANDROL CD200 IQ, Operation And Maintenance Manual

Page: 62 / 82

(Hold ’ok’ to shutdown)
Ext.
Auto.
Off Off
62 av 82
OPERATION AND MAINTENANCE MANUAL I ENG_OMM_CD200IQ_P03 I 2023-03-16
@Pandrol 2023
(5)
(6)
(7)
(1) (2) (3) (4)
Fig 89.
Fig 90. Storing the clipping/de-clipping plates.
Boost function
If a clip is jammed due to rust or other, the boost function
can be used to gain extra power.
1. Set the machine to manual mode by pressing the
button (2) on the control panel.
2. Activate the boost function by pressing the button (4).
3. Press the button (6) to de-clip.
8.3.4. De-clipping
1. Ensure that all necessary adjustments and settings is
carried out according to instructions in sections 8.3.1,
8.3.2 and 8.3.3.
2. Set the machine to manual mode by pressing the
button (2) on the control panel.
3. Set the tool to de-clipping mode ”Ext” by pressing the
button (1) on the control panel.
4. Position the work head over the center of a clip
assembly.
5. Hold the dead man’s grip (7) to enable operation.
6. Press and hold the button (6) to manually de-clip the
clips. Press the button (5) to retract the clipping arms.
7. Make sure that the FASTCLIP does not have any
damage to neither the clip or the insulator.
8. Set the machine to Auto mode maskinen i Auto-läge
by pressing the button (2) on the control panel.
9. Bring the machine to the next sleeper.
Initiate a de-clipping cycle by pressing the button (5).
The clipping arms will retract automatically.
8.4. Storing clip/de-clipping plates
Double pins are located on both sides of the power pack
where to store the plates when not in use.