15
■
■
+
(Turbo mode “ ”)
Low
Medium
High
(You may smell some chlorine during electrolysis.)
You can only switch the electrolytic strength for
“Air volume”. The electrolytic strength for
“Turbo” mode is “High” and cannot be switched.
(The factory setting of the electrolytic strength
is “Medium”.)
If you are not satisfied with the smell in the room,
or if you want to improve the sterilization effect,
select “High” or “Turbo” mode.
The product is in standby mode
Select your desired electrolytic strength,
press and at the same time
to confirm and exit from the switching
state.
(The right figure shows the corresponding
electrolytic strength.)
In the switching state, when you press
, the indicator switches level by
level among , and .
The following figure shows the change of
electrolysis strength.
Press and hold the button for about
3 seconds to enter the switching state.
Selecting the electrolytic strength
●
●
●
(During the cleaning operation, a gentle breeze may blow out and the clean indicator lights on.
After cleaning, the clean indicator lights off.)
Cleaning operation (Auto)
In order to keep its inside clean, the product will automatically perform the cleaning operation
regularly.
Do not disconnect the power plug since automatic control is
active when the product is idle.
Please check that there is water in the tank as the cleaning
operation is not possible when the tank need to add water.
Notice
(Clean indicator lights on)
OPERATION
OPERATION
