29
●
●
●
●
→
→
→
→
1
2
If a problem is encountered, please investigate it by going through the following items.
If the problem still persists, please disconnect the power plug and contact the dealer for repair.
Please confirm the following
Possible situation
The air volume is small.
Is the air inlet or the HEPA composite filter clogged with dust or
the like?
Clean the filter. (Page 21, 22)
Is there incrustation or dust accumulated on the sterilization
filter assembly?
No air is blown out.
If no air is blown out even after 20 seconds have elapsed,
contact the dealer.
Check whether there are salt tablets in the automatic salt tablet
adding assembly.
Make sure that salt tablets have been put to the automatic salt
tablet adding assembly. (Page 12)
Have 20 seconds elapsed after is pressed?
The product enters preparatory operation in about 20 seconds
after is pressed. (Page 13)
Remove the incrustation and dust. (Page 24)
Q1
A
●
·
·
●
Q2
A
●
→
Q3
A
●
Please confirm the following before you put questions forward or send the product for repair.
To turn off the status indicator.
The drain indicator does not light on.
Even if the maintenance indicator
lights on, the product can still
work. (The status indicator does
not blink in red.)
The status indicator of this product
can be turned off.
Because the drainage frequency and
time are reset each time, if drainage
is performed before the drain indicator
lights on, the drain indicator does not
light on.
This is temporary. When the cleaning
reset indicator lights on, clean the tray
and sterilization filter. When the
electrode reset indicator blinks, get
prepared to replace the electrode unit.
During operation, press and
at the same time for approximately 3
seconds. The status indicator is turned
off.
The indicator blinks in red (notifying of
water addition, drainage, maintenance,
etc.) even if the status indicator is turned
off.
If the maintenance indicator lights on
because the cleaning reset indicator
lights on and the electrode reset
indicator blinks, the status indicator
does not blink in red. Even if the
maintenance indicator lights on, the
product can still work.
To make it light on again, press the
buttons at the same time again for
approximately 3 seconds.
(The status indicator lights on.)
TROUBLESHOOTING
FAQ
OTHER
INFORMATION
