20
Behind the front panel (operating section)
Refer to page 21 for descriptions of how to detach the front panel (operating section).
q
Use button [USE]
Use this button when adding/replacing the HDD units, or
when changing the operational mode.
Install/remove HDD units (
☞
page 52)
Determine the operational mode of the hard disk drives
(
☞
page 54)
w
Dummy board
When installing an optional RAID board (WJ-HDB601E),
remove the dummy board and install it.
e
Operation buttons
Use this button to operate the menu while the front
panel (operating section) is detached. Refer to page 17
for further information about the menu operation button.
CDA B
:
Same as the arrows button
ESC:
Same as the [SETUP/ESC] button
SET:
Same as the [SET] button
r
HDD canister
Locally procured hard disk drive is installed in the canis-
ter. Refer to page 133 for how to add/replace the hard
disk drives. Contact your dealer about purchasing hard
disk drives. At the time of shipment from the factory, the
leftmost canister has been already installed.
t
HDD slots
At the time of shipment from the factory, one canister
has been already installed in the leftmost slot of the HDD
canister slots. Up to 4 hard disk drives can be installed.
y
RAID switch [RAID]
Use this switch to change the operational mode of the
hard disk drives (Single/RAID5/RAID6). (
☞
Page 54)
S:
Single mode
R5:
RAID 5 mode
R6:
RAID 6 mode
Default:
S
Important:
• Do not change the operational mode of the hard disk
drives after running the system. If it is changed, it may
become impossible to read recorded data correctly.
u
HDD indicators
These indicators will not light/blink. Check the status of
the hard disk drives by the HDD indicators (
☞
page 16)
on the front panel.
i
Removal knob
Use this knob to remove an HDD unit.
o
HDD unit brace
This brace is provided for transportation. It is necessary
to remove this brace when installing hard disk drives.
When this product is to be transported, it is necessary to
attach the brace.
When this product is not to be transported anymore, it
does not affect the operation of the recorder even with
the brace attached.
Do not remove the blue protective film sticking to the
HDD unit brace since the film is intended to protect the
HDD units from scratches.
y
u i
o
q w
e
r
t
USE
ESC
SET
RAID
MAINTENANCE
STS A/F
STS A/F
STS A/F
STS A/F
MOUSE
ERROR
TIMER
STS
A/F
HDD 1
HDD 2
HDD 3
HDD 4
OPERATE
ALARM
ALARM
RESET
ALARM
SUSPEND
