r
Do not install the projector at elevations of 2 700 m (8 858') or higher above sea level.
r
Do not use the projector in a location that the ambient temperature exceeds 45 °C
(113 °F).
Using the projector in a location that the altitude is too high or the ambient temperature is too high may shorten
the life of the components or result in malfunctions.
When the optional wireless module (Model No.: AJ-WM50) is attached, do not use the projector in a location that
the ambient temperature exceeds 40 °C (104 °F).
r
Projection in all 360° direction is possible.
360°
360°
360°
360° vertically
360° horizontally
360° tilted
(combination of vertical and horizontal)
Cautions when setting the projectors
f
Use the adjustable feet only for the floor standing installation and for adjusting the angle. Using them for other
purposes may damage the projector.
f
When installing the projector with a method other than the floor installation using the adjustable feet or the
ceiling installation using the ceiling mount bracket, use the four screw holes for ceiling mount (as shown in the
figure) to fix the projector.
In such case, make sure that there is no clearance between the screw holes for ceiling mount on the projector
bottom and the setting surface by inserting spacers (metallic) between them.
f
Use a torque screwdriver or Allen torque wrench to tighten the fixing screws to their specified tightening torques.
Do not use electric screwdrivers or impact screwdrivers.
(Screw diameter: M4, tapping depth inside the projector: 8 mm (5/16"), torque: 1.25 ± 0.2 N·m)
Screw holes for
ceiling mount (M4)
Adjustable feet
Positions of screw holes for ceiling mount
and adjustable feet
f
Do not stack the projectors.
f
Do not use the projector supported by its top.
f
Do not block the intake and exhaust vents of the projector.
f
Avoid heating and cooling air from the air conditioning system directly blow to the intake and exhaust vents of
the projector.
20 -
ENGLISH
Chapter 1 Preparation - Precautions for use