中文 ( 简体 )
PLEASE SELECT LANGUAGE.
ENTER
SELECT
INITIAL SETTING
2) Press the <ENTER> button to proceed to the following initial setting.
Initial setting (projector setup)
If necessary, change the setting of each item.
INITIAL SETTING
PROJECTION METHOD
AUTO
16:10
NORMAL
If STANDBY MODE is set to ECO,
you cannot use network functions
when the projector is standing by.
Also, you cannot use some RS-232C
protocol commands.
SCREEN FORMAT
SCREEN POSITION
STANDBY MODE
ENTER
RETURN
SELECT
1) Press
as
to select an item.
Item
Description
[PROJECTION METHOD]
Set [PROJECTION METHOD] depending on the installation mode.
[SCREEN FORMAT]
Set the aspect ratio of the screen.
[SCREEN POSITION]
Set the display position of the screen.
[STANDBY MODE]
Set the operation mode during standby.
2) Press
qw
to switch the setting.
f
When all settings are completed, proceed to Step
3)
.
3) Press the <ENTER> button.
f
Confirm the setting value and complete the initial setting.
Setting [PROJECTION METHOD]
If the screen display is upside down or is reversed, please change the settings, refer to
“Installation mode”
(
x
page 35). After initialization, you can change the settings from the [PROJECTOR SETUP] menu →
[PROJECTION METHOD].
1) Press
as
to select the [PROJECTION METHOD].
2) Press
qw
to switch the settings.
f
When set to [AUTO], the built-in angle sensor detects the orientation of the projector and automatically
switches to [FRONT/DESK] or [FRONT/CEILING]. Normally, set to [AUTO].
f
To project from the rear of the screen, select [REAR/DESK] or [REAR/CEILING] (using a translucent
screen).
Setting [SCREEN FORMAT] and [SCREEN POSITION]
Set the screen aspect ratio and display position according to the screen being used. When the initial setting is
complete, you can change the setting from the [DISPLAY OPTION] menu → [SCREEN SETTING] → [SCREEN
FORMAT]/[SCREEN POSITION].
48 -
ENGLISH
Chapter 3 Basic Operations - Switching on/off the projector