ENGLISH - 91
Power/Warning Indicators
If a problem should occur inside the projector, the power indicator <ON(G)/STANDBY(R)> and the warning indicator
<WARNING> will inform you by lighting or blinking. Check the status of the indicators and remedy the indicated problems as
follows.
Attention
f
Before you take a remedial measure, follow the procedure of switching the power off indicated in “Powering Off the
Projector” (
x
page 36).
Power indicator <ON(G)/STANDBY(R)>
Warning indicator <WARNING>
Power indicator
<ON(G)/STANDBY(R)>
Warning
indicator
<WARNING>
Status
Cause
Solution
Off
Off
The power plug is not
connected to the outlet.
--
Connect the power plug
to an outlet.
Red
Blinking
Lighting in red It has reached the replace-
ment time of the lamp unit.
f
The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[
(Eco)]).
f
Replace the lamp
unit.
Blinking
Blinking in red
It has exceeded the re-
placement time of the lamp
unit and the projector is
turned off automatically.
f
The indicator blinks
when the usage time of
the lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[
(Eco)]).
Green
Lighting
Lighting in red
The replacement time of
the lamp unit is displayed.
(Projecting)
f
Is the lamp
replacement warning
icon
displayed when turn
on or turn off the
projector?
f
The indicator lights up
when the usage time of
the lamp unit reaches
20 000 hours (when
[Lamp control] is set to
[
(Eco)]).
f
Replace the lamp
unit.
Lighting
Blinking in red
It has exceeded the re-
placement time of the lamp
unit and the projector is
turned off automatically.
f
The indicator blinks
when the usage time of
the lamp unit reaches
22 000 hours (when
[Lamp control] is set to
[
(Eco)]).
Blinking
Off
The power cord is plugged
and the lamp is turned off.
(Ready state)
f
[Power management] is set to [Ready].
If a video signal is input in Ready mode, or when
you press any button other than the power
<
v
/
b
> button, the luminous lamp turns on
and the projector enters the projection state.
Pressing the power <
v
/
b
> button during
the Ready state will enter the standby state.
(
x
page 68)
Chapter 6 Maintenance - Power/Warning Indicators