44 - ENGLISH
Using the Daylight View Lite function
The Daylight View Lite function improves the vividness of the image even if it is projected under a bright light.
button
1) Press the <DAYLIGHT VIEW> button on the remote control.
f
The Daylight View Lite function will be switched enable/disable each time you press the button.
Note
f
For details, please refer to the [Color adjust] menu → [Daylight View] (
x
page 55).
Setting the remote control ID numbers
When you use the system with multiple projectors, you can operate all the projectors simultaneously or each projector
individually by using single remote control, if unique ID number is assigned to each projector.
After setting the ID number of the projector, set the same ID number to the remote control.
There are seven different ID codes (ALL, Code 1~Code 6), the initial ID number is [ALL].
button
button
1) The ID numbers of the projector are set by pressing the <IMAGE> button one time to six times
while holding down the <MENU> button.
f
The number of times you press the <IMAGE> button corresponds to the desired ID code number.
The number of times
to press the <IMAGE> button is as follows:
Code 1= Once, Code 2= Twice, Code 3= 3 times, Code 4= 4 times, Code 5= 5 times, Code 6= 6 times.
f
The ID code is changed when the <MENU> button is released.
Attention
f
The ID number set on the remote control will be stored unless it is set again. However, it will be erased if the remote control
is left with dead batteries. Set the same ID number again when the batteries are replaced.
Note
f
Set the ID number of the projector from the [Expand] menu → [Remote control]. (
x
page 71)
f
The ID code is reset to [ALL] (default) by pressing the <MENU> button and <IMAGE> button at the same time for five
seconds or more.
f
If the <IMAGE> button is pressed seven times or more, the operation is invalid, the ID code cannot be changed.
Chapter 3 Basic Operations - Basic operations by using the remote control
