Chapter 2
Getting Started — Attaching/removing the projection lens (optional)
50 - ENGLISH
3) Insert the projection lens by aligning the mark on the projection lens (orange) with the mark on the
projector (
E
on the left side of LOCK) and turn clockwise until it clicks. (Fig. 3)
4) Secure the projection lens with the supplied lens fixing screw. (Fig. 4)
f
Use a Phillips screwdriver to secure it in screw hole A located to the right of mark on the projection lens
(orange).
f
Some lenses may not have a screw hole A for securing the projection lens.
Attention
f
Turn the projection lens counterclockwise to confirm that it does not come out.
f
Store the removed lens hole cover in a safe place.
f
After attaching the projection lens, turn on the projector and confirm the [LENS TYPE] setting. Change the setting if the type is different from
the projection lens attached to the projector. (
x
page 73)
Continue to execute the lens calibration after confirming the [LENS TYPE] setting. (
x
page 73)
f
The lens hood needs to be mounted to the projector when an interchangeable projection lens is used under the condition that throw ratio is
greater than 3.0 in the North America region. Always ask a qualified technician or your dealer to mount the lens hood.
The throw ratio described here is a value calculated by dividing the actual projection distance by the projected image width.
The lens hood is assembled and mounted to the projector using the following supplied components.
Lens hood 1, Lens hood 2, Lens hood mounting plate 1, Lens hood mounting plate 2, Lens hood screws, Knurled head screws
For the assembly and attachment, refer to the separate document “Mounting the lens hood”. The components and document of the lens
hood may not be supplied depending on the country or region where you purchased the product.
Removing the projection lens
Remove the projection lens using the following procedure.
Lens release button
Fig. 1
Screw
Lens hole cover
Fig. 3
Fig. 2
1) Remove the lens fixing screw.
f
Use a Phillips screwdriver to remove the first screw to the right of the mark on the projection lens (orange).
2) Remove the projection lens by turning it counterclockwise while pressing the lens release button.
(Fig. 1)
f
Turn the projection lens counterclockwise until the mark on the projection lens (orange) is aligned with the
mark on the projector (
E
on the left side of LOCK).
f
Proceed to Step
3)
when carrying or storing the projector.
