Chapter 7
Appendix — Technical information
ENGLISH - 243
3) Press the <ENTER> button on the control panel.
f
It will go into an IP address setting mode (where the self-diagnosis display is blinking in 0.5 second
intervals).
f
It will not go into the IP address setting mode even if the <ENTER> button on the remote control is pressed.
4) Press the <AUTO SETUP> button on the remote control or control panel.
f
[DHCP] is set to [ON].
f
The setting is reflected to the [NETWORK] menu
→
[NETWORK SETUP]
→
[DHCP].
f
The IP address setting mode is canceled when the <AUTO SETUP> button is pressed, and the setting is
displayed in the self-diagnosis display for approximately two seconds.
“IPo”
Display end
Note
f
The IP address setting mode is canceled when no setting operation is performed for 10 seconds or longer in the IP address setting mode.
f
The IP address will be set to the following factory default setting when the <DEFAULT> button on the remote control is press while in the IP
address setting mode.
[DHCP]
OFF
[IP ADDRESS]
192.168.0.8
Specifying the IP address
Enter the IP address when there is no DHCP server in the network where the projector is to be connected.
1) Press the <ON> side of the <MAIN POWER> switch to turn on the power.
f
The power indicator <ON (G)/STANDBY (R)> lights in red, and the projector enters the standby mode.
2) Press and hold the <STATUS> button on the remote control for three seconds or more.
f
Currently set IP address is displayed in the self-diagnosis display at the side of the projector.
3) Press the <ENTER> button on the control panel.
f
It will go into an IP address setting mode (where the self-diagnosis display is blinking in 0.5 second
intervals).
f
It will not go into the IP address setting mode even if the <ENTER> button on the remote control is pressed.
4) Press
asqw
to enter the IP address.
f
Press
qw
to switch the display of the IP address in the self-diagnosis display. Press
qw
to display the
address to change, and then press
as
or the number (<0> - <9>) buttons to set the address.
f
Once all the addresses are entered, proceed to Step
5)
.
5) Press the <ENTER> button on the remote control or control panel.
f
[IP ADDRESS] is set to the entered IP address.
f
The setting is reflected to the [NETWORK] menu
→
[NETWORK SETUP]
→
[IP ADDRESS].
f
The IP address setting mode is canceled when the <ENTER> button is pressed, and the settings are
displayed in the self-diagnosis display in two second intervals as follows. Next display is an example when
[IP ADDRESS] is set to 192.168.0.10.
“192”
“168”
“000”
“010”
Display end
Note
f
The IP address setting mode is canceled when no setting operation is performed for 10 seconds or longer in the IP address setting mode.
f
The IP address will be set to the following factory default setting when the <DEFAULT> button on the remote control is press while in the IP
address setting mode.
[DHCP]
OFF
[IP ADDRESS]
192.168.0.8
