Chapter 3
Basic Operations — Switching on/off the projector
62 - ENGLISH
f
It may take longer to start the projection when the [PROJECTOR SETUP] menu
→
[STANDBY MODE] is set to [ECO] compared to the time
when it is set to [NORMAL].
f
If the power was turned off at the previous use by pressing the <OFF> side of the <MAIN POWER> switch or by using the breaker directly
while projecting, the power indicator <ON (G)/STANDBY (R)> lights up in green and an image is projected after a while when the power
is turned on by pressing the <ON> side of the <MAIN POWER> switch or by turning the breaker on with the power plug connected to the
outlet. This applies only when the [PROJECTOR SETUP] menu
→
[INITIAL STARTUP] is set to [LAST MEMORY].
f
The light output will decrease to approximately 1/2 when using the projector with AC 100 V to AC 120 V.
When the initial setting screen is displayed
When the projector is switched on for the first time after purchase, as well as when the [PROJECTOR SETUP]
menu
→
[INITIALIZE]
→
[ALL USER DATA] is executed, the focus adjustment screen is displayed after projection
starts, and then the
[INITIAL SETTING]
screen is displayed. Set them according to the circumstances.
In other occasions, you can change the settings by menu operations.
If you press the <MENU> button while the
[INITIAL SETTING]
screen is displayed, you can go back to the
previous screen.
Focus adjustment
Adjust the focus to display the menu screen clearly.
You may also need to adjust the zoom and lens shift.
Refer to “Adjusting the focus, zoom, and lens shift” (
x
page 71) for details.
1) Press
asqw
to adjust the focus.
52
FOCUS POSITION
LENS
FOCUS
ADJUST
2) Press the <MENU> button to proceed to the initial setting.
Initial setting (display language)
Select the language to show on the screen.
After completed the initial setting, you can change the display language from the [DISPLAY LANGUAGE] menu.
1) Press
as
to select the display language.
ENTER
1/7
Please select DISPLAY LANGUAGE.
INITIAL SETTING
SELECT
SET
2) Press the <ENTER> button to proceed to the initial setting.
