[PROJECTOR SETUP] menu
ENGLISH - 111
Settings
has been turned off with the input set to SDI2,
projection will start with the SDI1 input, even when
[STARTUP INPUT SELECT] is set to [LAST USED].
[RS-232C]
Set the communication conditions of the <SERIAL
IN>/<SERIAL OUT> terminal.
1) Press
▲▼
to select [RS-232C].
2) Press the <ENTER> button.
▶
z
The
[RS-232C]
screen is displayed.
3) Press
▲▼
to select an item.
▶
■
To set the communication
condition of the <SERIAL IN>
terminal
4) Select [(IN) BAUDRATE] in Step 3).
5) Press
◀▶
to switch [(IN) BAUDRATE].
▶
z
The setting will change as follows each time
you press the button.
[9600]
[19200]
[38400]
6) Press
▲▼
to select [(IN) PARITY].
7) Press
◀▶
to switch [(IN) PARITY].
▶
z
The setting will change as follows each time
you press the button.
[NONE]
[EVEN]
[ODD]
▶
■
To set the communication
condition of the <SERIAL OUT>
terminal
4) Select [(OUT) BAUDRATE] in Step 3).
5) Press
◀▶
to switch [(OUT)
BAUDRATE].
▶
z
The setting will change as follows each time
you press the button.
[9600]
[19200]
[38400]
6) Press
▲▼
to select [(OUT) PARITY].
7) Press
◀▶
to switch [(OUT) PARITY].
▶
z
The setting will change as follows each time
you press the button.
[NONE]
[EVEN]
[ODD]
▶
■
To set the response
4) Select [RESPONSE(ID ALL)] in Step 3).
5) Press
◀▶
to switch [RESPONSE(ID
ALL)].
▶
z
The setting will change as follows each time
you press the button.
[ON]
[OFF]
[ON]
Returns the response when the ID
setting is ALL.
[OFF]
Does not return the response when the
ID setting is ALL.
6) Press
▲▼
to select [GROUP].
7) Press
◀▶
to switch [GROUP].
▶
z
The setting will change as follows each time
you press the button.
[A]
[B]
[Z]
[A] to [Z]
Controls multiple projectors
simultaneously by sending the ID of
RS-232C. Set the group from [A] to [Z].
The projector responds when the ID of
RS-232C matches the setting.
8) Press
▲▼
to select [RESPONSE(ID
GROUP)].
9) Press
◀▶
to switch [RESPONSE(ID
GROUP)].
▶
z
The setting will change as follows each time
you press the button.
[ON]
[OFF]
[ON]
Returns the response when the ID
setting is GROUP.
[OFF]
Does not return the response when the
ID setting is GROUP.
Note
z
Refer to “<SERIAL IN>/<SERIAL OUT> terminal”
(
page 167) for the <SERIAL IN>/<SERIAL OUT>
terminals and ID transmission in RS-232C.
