10
11
Name of part
Brushless motor
Connector for motor cable and
CS signal cable
Ground terminal
Oil seal
Output shaft
Safety precaution label
is affixed to the product.
O-ring (not provided on a round shaft model)
Motor nameplate
Bracket B
Frame
Brushless amplifier
Mounting hole (2 places)
Front panel
PowerLED (PWR)
Green: Power ON
AlarmLED (ALM)
Red: Trip*
[Front view]
Speed setting knob
RUN switch (RUN/STANDBY)
* Trip means that a protection circuit operates and stops.
Rotate direction selector switch (CW/CCW)
CW / CCW is the direction of motor shaft rotation.
CW:
clockwise rotation viewed from the motor shaft side
CCW:
counterclockwise rotation viewed from the motor
shaft side
The direction of rotation of the gearhead output shaft
may change. (See page 28)
Name of part
You can remove the front panel by
pulling it while not attaching the
brushless amplifier to the equipment.
[Front view without Front panel]
[Rear view]
Connector for
communications (SER)
Connector for motor
connection (MOTOR)
Connector for
control signals (I/O)
Wire extraction button
Refer to page 19
for how to
operate.
I
1 input enabled switch
(SW3)
Nameplate
(Displayed on the side)
Deceleration time setter
(DEC)
Acceleration time setter
(ACC)
Grounding terminal ( )
2 places
Terminal block for
power input (POWER)
Power supply line
connection hole
Do not loosen this screw.
Do not loosen this screw.
Heat sink
