22
23
Wiring example when using external speed setter as speed command and operating with external input
When using the
I
1 input, turn on the
I
1 input enable switch (SW3) on the back of the
product and set the RUN switch on the front of the product to RUN.
When using the
I
2 input, set the CCW / CW switch on the front of the product to CCW.
When setting the speed with the FIN terminal, it is necessary to change the parameter.
Change of
direction
Run
command
02
Connector
for control
signals (I/O)
Variable resister for
external speed setting.
5 kΩ
B characteristic 1/4 W
10
3
1
2
1
01
＋
5V
FIN
COM
I
3
I
4
I
5
I
2
I
1
Photo-coupler
Internal
power
supply
(+5 V)
I
1,
I
2,
I
3,
I
4,
I
5
COM
COM
01, 02
Vce max DC30 V
Ic max 50 mA
1 kΩ
Input circuit
Output circuit
FIN characteristic
4.5
0.5
0
0
4000
(V)
5
(Upper speed limit)
(Lower speed limit)
FIN Input voltage
Speed instruction value
(r/min)
(Central value)
To directly drive the relay (RY) using the output
terminal (O1, O2 to COM), please insert a flywheel
diode (FD). (See the figure on the right)
COM
RY
FD
01, 02
Wiring
Connector for motor connection (MOTOR)
Connector on amplifier side: Parts No. 5569-08A1-210 (Molex Inc.) or equivalent.
(mating connector: Housing 5557-08R-210, Terminal 5556PBTL)
Terminal
number
Terminal
symbol
Terminal name
Terminal explanation
1
U
Motor U phase
Connect motor wire U, V and W.
2
V
Motor V phase
3
W
Motor W phase
4
5VS
High voltage 5 V
Not isolated from commercial power source.
Use care to avoid electric shock and
grounding fault.
5
CS1
CS signal 1
6
CS2
CS signal 2
7
CS3
CS signal 3
8
GNDS
High voltage GND
• High voltage is applied to motor wire and CS signal line; Use caution for avoiding electric shock.
• Use a motor extension cable (option) for extending motor wire.
• No.4 to 8 terminals of option cable are shielded, But the shield material is not grounded.
please do not ground the shield material in order to avoid malfunctions or damages.
Connector for communications (SER)
Modular jack: 85503-0001 (Molex Inc.) or equivalent
(RJ45)
Terminal
number
Terminal
symbol
Terminal explanation
1
—
Do not connect anything.
2
+5V
DC5 V power supply for Digital key pad
3
SOT
Interface for Digital key pad or PANATERM for BL
4
SIN
5
—
Do not connect anything.
6
—
Do not connect anything.
7
COM
Power supply GND for Digital key pad
8
SCK
Interface for Digital key pad
• Connection of Digital key pad of an option is possible.
Digital key pad connecting cable of an option (DV0P383**) is required.
• The terminal number of a modular jack is as shown below.
8
1
