4-8
System Programming
4.1.2
Programming Ways
Going to another program address
After pressing STORE, you can go to another program with either
of the following two methods:
(1) • To go to the next larger program address:
Press Soft 1 (SKP+) or VOLUME
(DOWN).
• To go to the next smaller program address:
Press SHIFT + Soft 1 (SKP–) or VOLUME
¨
(UP).
(2) To go to a specific program address:
Press END, then enter the Program Address.
Method (1) is useful when you want to perform a series of
programs consecutively. For example, to change the programming
in addresses [000] to [008], use this method. You can move from
[000] to [001], from [001] to [002], and so on by pressing the
SKP+ or VOLUME
. You can move in reverse order from
[008] to [007], etc. by pressing the SKP– or VOLUME
¨
.
This method can also be used to move between neighboring
program groups: For example, you can move between the program
addresses [008] and [100], [120] and [200], and so on. Also, you
can move between the smallest program address [000] and the
largest one [992].
Method (2) is useful when you wish to jump to another program
address. For example, you have just finished with program [006]
and now you want to go to program [301]. Neither SKP+/
VOLUME
nor SKP– or VOLUME
¨
is convenient in this
case. So you should press END and enter 301.
Confirming the entries
You may review the stored programming without making any
changes.
Going back to the operation mode
Two ways are available to go back to the operation mode:
(1) Lift the handset while in programming mode.
(2) When the Initial Message:
SYS-PGM NO? —>
is
displayed, press the PROGRAM button.
(To display the Initial Message, press END.)
Note
The following programming instructions suppose that you have already
entered programming mode and that you will use Method (2).
