2.5 Utility
42
PC Programming Manual
2.5
Utility
2.5.1
Utility—Diagnosis
Performs diagnostic tests on cards installed in the PBX, to identify the source of problems.
If any of the tests listed here returns the result "NG" ("No Good"), contact your dealer. Test results
can be saved as a TXT-format (text) file.
When testing is complete, any cards that were set to OUS status must be returned to INS status if
they are to be used again.
Card Test
Tests the relevant functions of a card to ensure that it is operating correctly. The tests carried out vary
according to the type of card being tested.
The tests that are performed on each card are as follows:
A check mark indicates that the test is available for that card.
To perform a card test
1.
From the
Utility
menu, select
Diagnosis
.
2.
Click on the
Status
cell of the card to be tested, and set it to "OUS".
To perform the EXT-CID path test, set the status of both the EXT-CID card and the card in slot 1
to "OUS".
3.
Click on the cell showing the card type.
A new window will be displayed.
4.
Select the
Card Test
option.
A new window will be displayed.
5.
Click
OK
to perform the test(s).
The error report will be displayed. When all tests are completed, the words "Test End!" will be
shown on the last line of the output.
6.
Select an option:
SLC
8
HLC4
PLC
4
PLC
8
LCO
T
E
CHO8
MS
G
2
SV
M2
DP
H4
EX
T
-C
ID
Local loop back diagnosis
Card CT Bus diagnosis
DTMF Receive test port
MSG/SVM Card DTMF receive
test
EXT-CID path test
