KX-NT265 (software version 2.00 or later only)
IP Address*
1
Subnet Mask Address*
2
Default Gateway Address*
3
To set the IP address of the IP-PT
To set the subnet mask address
To set the default gateway address
To enter the IP address of the MPR card (PBX IP Address)
To start programming
Supply power to the IP-PT.
Press PROGRAM
while "Searching" is displayed.
Press VOLUME to
select "Network".
Press SP-PHONE.
Press VOLUME to
select "DHCP (Disable)".
Press SP-PHONE
twice.
Press SP-PHONE.
Press VOLUME to
select "Subnet Mask".
Press SP-PHONE.
Press SP-PHONE.
Press VOLUME to
select "Default GW".
Press SP-PHONE.
Press SP-PHONE.
Press HOLD
twice to return
to the Menu screen.
HOLD
Press VOLUME
to select "PBX".
Press SP-PHONE
twice.
Press
SP-PHONE.
To the VLAN settings
To end programming
To set VLAN parameters
OR
Press STORE.
PBX IP
Address
Press HOLD
to return to the
Menu screen.
HOLD
The IP-PT will reboot
and can then be
registered to the PBX.
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
64
IP Networking Guide
Document Version 2010-08
4.5.1 Assigning the IP Addressing Information
Summary of Contents for KX-NCP500
