4.
a.
From the system menu, click
Private Network
.
b.
Click
TIE Table
.
c.
In the
Own PBX Code
box, type the PBX code of
the local PBX in the network.
d.
In the first unused
Leading Number
box, type the
PBX code of the remote PBX in the network.
e.
In the corresponding
Trunk Group
list, select the
number of the trunk group to be used when making
calls.
f.
Set the number modification pattern, if necessary.
g.
Click
OK
.
5.
a.
From the system menu, click
Configuration
.
b.
Click
Slot
.
c.
Move the mouse pointer over the installed
V-IPGW16 card to display the menu of options.
d.
Click
Ous
.
You will see a confirmation message.
e.
Click
Yes
.
f.
Move the mouse pointer over the installed
V-IPGW16 card to display the menu of options.
g.
Click
Shelf Property
.
6.
a.
Click the
Outgoing Call
tab.
b.
Select the preferred
En-bloc Dialing setting
(
Overlap
(default) or
En-bloc
*1
).
c.
Click
OK
.
Document Version 2010-08
IP Networking Guide
43
4.2.3 Programming the Network Settings
Summary of Contents for KX-NCP500
