4.4 Programming the IP-EXT16 Card (KX-TDE series
only)
4.4.1 Assigning the IP Addressing Information
When an IP-EXT16 card is placed on the LAN for the first time, it is necessary to assign IP addressing
information to the card. This is done using the Maintenance Console.
1.
a.
Under
Configuration
, click
Slot
.
b.
Move the mouse pointer over the IP-EXT card. A
menu will be shown under the mouse pointer.
c.
Click
Ous
to set the card to out-of-service status.
d.
Move the mouse pointer over the IP-EXT card,
then click
Card Property
.
2.
a.
In the
IP Address
box, type the IP address of the
card.
*1
b.
In the
Subnet Mask
box, type the subnet mask
address of the network.
*2
c.
Click
Apply
.
3.
If the IP address of the default gateway needs to be
entered:
a.
Click
Common Settings
. A dialog box will
appear.
b.
In the
Gateway Address
box, type the IP address
of the default gateway.
*3
c.
Click
OK
.
Note
To activate any changes made in step
3
, it is
necessary to set all installed IP-EXT cards to
out-of-service status (
OUS
), then back to
in-service status (
INS
).
4.
Move the mouse pointer over the IP-EXT card, then click
INS
to set the card to in-service status.
*1
Valid IP address range: "1.0.0.0" to "223.255.255.255"
*2
Valid subnet mask address range: "0–255.0–255.0–255.0–255" (except 0.0.0.0 and 255.255.255.255)
*3
Valid IP address range: "1.0.0.0" to "223.255.255.255"
50
IP Networking Guide
Document Version 2010-08
4.4.1 Assigning the IP Addressing Information
Summary of Contents for KX-NCP500
