3.
Not using a DHCP server when the IP-PT is on the same LAN with the PBX
Only the PBX IP address can be assigned automatically to the IP-PT in process of being registered to the
PBX. For details about registering the IP-PT, refer to "4.6.1 Registering IP Telephones".
Follow the procedure below to assign the IP address of the IP-PT, the subnet mask address, and the default
gateway address manually.
If you need to set VLAN parameters, follow the procedure described in "4.5.2 Setting the VLAN
Parameters" after assigning the IP addresses without ending programming.
KX-NT300 series (except KX-NT321)
Select "Network".
ENTER
Select "Disable"
for DHCP setting.
ENTER
IP Address*
1
ENTER
To set the IP address of the IP-PT
Select "Default Gateway".
ENTER
Default Gateway Address*
3
ENTER
To set the default gateway address (if required)
To set the subnet mask address
Select "Subnet Mask".
ENTER
Subnet Mask Address*
2
ENTER
Select "IP Address".
To start programming
Press "SETUP" when it is displayed.
SETUP
Supply power to the IP-PT.
Return to the
Menu screen.
To enter the IP address of the Secondary PBX (optional for software version 2.00 or
later only)
PBX IP Address
ENTER
ENTER
Select "PBX".
Select "PBX IP
Address".
ENTER
ENTER
Select "Secondary
PBX".
Continued on next page
Document Version 2010-08
IP Networking Guide
55
4.5.1 Assigning the IP Addressing Information
Summary of Contents for KX-NCP500
