Panasonic HL-C1 Series, User Manual

Page: 29 / 170

CHAPTER 2 INSTALLATION
2-3
„ Installation Space
• Mount the controller so it is separated from surrounding ducts and other devices by
50mm or more to enable replacement, wiring, etc.
• If a panel door or other device is placed in front of the controller unit, separate it from
the controller by 100mm or more to avoid the influence of radiation noise or heat
generation.
• Ensure that there is an allowance of 100mm or more from the controller's front surface
to enable connection of sensors, wiring, etc.
2-3 Mounting the Controller
The controller can be mounted by fastening it with screws or by using a DIN rail.
„ Mounting the Controller with a DIN Rail
The controller can be mounted or removed from a 35mm width DIN
rail (DIN EN 50022) in 1-touch operation.
[Mounting]
1. Hang the top on the DIN rail.
2. Push the bottom of the controller to fasten it on the rail.
[Removal]
1. Insert the blade of a flat-bladed screwdriver in the mounting lever.
2. Pull down the mounting lever.
3. Raise the controller and remove it from the rail.
„ Mounting the Controller with Screws
• While referencing the external dimensioned diagram on page 10-6
use M3 screws to fasten the controller. Do not tighten screws
beyond 0.5N·m.
• To avoid breakage inside the controller, do not insert the screw tip
3.5mm or more from the side of the case.
• Use only the 4 screw holes included on the side of the case.
100mm
or more
50mm or more
50mm or more
AL1
O 1 1
O 12
AL2
O 21
O 22
V 1
I 1
V 2
I 2
I 11
I 12
TM 1
TM 2
I 21
I 22
GND
( )
( )
( )
( )
GND
N O T USE
COM .
N O T USE
HEAD 1
HEAD 2
LASER
BRIGHT
D ARK
AL1
O 1 1
O 12
AL2
O 21
O 22
V 1
I 1
V 2
I 2
I 11
I 12
TM 1
TM 2
I 21
I 22
GND
( )
( )
( )
( )
GND
N O T USE
COM .
N O T USE
HEAD 1
HEAD 2
LASER
BRIGHT
D ARK
AL 1
O 1 1
O 12
AL 2
O 21
O 22
V 1
I 1
V 2
I 2
I 11
I 12
TM 1
TM 2
I 21
I 22
GND
( )
( )
( )
( )
GND
N O T USE
COM .
N O T USE
HEAD 1
HEAD 2
LASER
BRIGHT
D ARK
50mm
以上
50mm
以上
50mm or more
50mm or more