Dial-in setup for PPP server
144
FP Web-Server V2.810 EN
The dial-up, connect screen is displayed.
'Dial-up' and test the FP Web-Server:
If the dial-up, connect screen is not displayed use:
Start
Control
Panel
Network and Dial-up Connections
“Null modem with
COM1 and 19200bps to PPP server”
1.
Enter the name and password as defined in the FP Web-Server
configuration. Click [Connect]
The 'dial-up' process can take a few seconds. Upon a successful
connection an icon is displayed in the system status bar.
To disconnect later, click on this icon and select 'Disconnect'.
2.
Use a standard Internet browser that is set up as described under
Internet Browser to Test the FP Web-Server (see p. 37)
3.
In the location field the IP address of the PPP server can be entered,
e.g. http://192.168.206.4 (see FP Web-Server settings under PPP
server (see p. 130))
The page "MAIN.HTM" as setup with the Configurator should be
displayed.
Pin assignment of the RS232C null modem cable
The computer's COM port is directly connected to the FP Web-Server's
9-pin port via a null modem cable.
Use a standard null modem adapter having 9-pin, female, RS232C
connectors on both sides. The minimum wiring should be as follows: 2-3 ;
3-2 ; 5-5. (This is the minimum number of wires needed.) The minimum
wiring connects the GND and the data lines only. A 25-pin connection
should be as follows:
Comment:
The bridges 4-5 and 6-20 on each side are not absolutely necessary. They
are only essential for questions of compatibility.
