Panasonic Elite Big PAC-i S-200PE3E5B, Technical Data & Service Manual

Page: 279 / 316

8 8
Important Safety Instructions
WARNING
Installation Precautions
Do not install yourself
Installation should always be performed by your dealer or a professional service provider.
Electric shock or fire may result if an inexperienced person performs any installation or wiring procedures
incorrectly. •
Use only specified air conditioners •
Always use only air conditions specified by the dealer.
Precautions for Use
Do not touch switches with wet hands •
Protect the remote controller from water Damage to the system can result. •
Stop the system and turn the power off if you sense unusual smells or other irregularities •
Do not swallow the battery. •
Do not repair •
Contact your dealer before moving the system •
Moving and Repair Precautions
Electric shock and damage to the system can result.
Continuing operation when the system is out of order can result in electric shock, fire, and damage to the system.
Contact your dealer.
Never repair the system by yourself.
Contact your dealer or a professional service provider about moving and reinstalling the system.
Electric shock or fire may result if an inexperienced person performs any installation procedures incorrectly.
Press to change the fan speed.
Press to change the flap
direction.
ECONAVI
nanoeX
Use this to set the clock.
Press at the top center and then
slide down.
raises the temperature
setting 1 °C at a time.
lowers the temperature
setting 1 °C at a time.
Press to enable or disable
energy saving.
/ / / / /
Use for operating with a timer.
RC
RESET
17. RC address
button
RC
ADR
Press to set addresses.
Optional Controller (Remote Controller)
Wireless Remote Controller
8-1. Names and Operations
1. Operation Display
Displays the operation status.
(The figure shows all the statuses.)
2. Start/Stop
button
Pressing this button once starts and
pressing again stops the operation.
3. Fan speed
button
4. Flap button
5. ECONAVI button
Press to set ECONAVI.
Press to set nanoe™ X.
Use this when connected to an
aftermarket fan.
6. nanoe™ X button
7. Ventilation button
8. Clock button
12. Mode Select
button
Press to switch the operation mode.
14. Filter button
16. RC reset button Use this button after changing the
batteries.
13. Energy saving
button
15. Timer setting
buttons
Press to turn off the filter lamp on
the receiver.
9. Cover
11. Temperature
setting buttons
10. Transmitter
REMOTE CONTROLLER
From this page, the names of remote controller’s
buttons will be indicated with the above illustrations.
E.g.: Start/Stop button
1 remote controller can control a group of up to 8 indoor units. (See page 8-8)
CZ-RWS3
1
2
3
6
8
9
5
7
10
11
12
14
15
16
17
13
4
8-3
SM830276-00_欧州向け R32シングル TD＆SM.indb 3 19/02/18 11:16:03