Panasonic DP-180/190, Service Manual

Page: 3 / 296

3
Important Notice
Please read this notice completely BEFORE repairing or
installing any optional accessories. As failure to properly install
the additional board or connector with the power ON could
damage the machine’s SPC or SC board.
Please follow the instructions below:
1. It is essential that you turn OFF the Main Power Switch located
on the Left Side of the machine.
2. It is essential that you unplug the AC Power Cord from the wall
outlet. (During a Lightning Storm, to prevent electrocution
disconnect the Telephone Line Cable first before unplugging
the AC Power Cord.)
3. Please read the installation instructions carefully and follow
each step.
<Example: UF-9000>
Note:
O = Power OFF, l = Power ON
Note:
If the Hard Disk Drive Unit is installed, to prevent a Scan Disk Function from being
performed (similar to Windows OS when the power is abruptly interrupted), it is
important to follow the step sequence below when turning OFF the Power Switch on the
machine.
1. If the machine is in the "ENERGY SAVER MODE", you may turn the Power Switch on the Left Side of
the machine to the OFF position. If it is not in the "ENERGY SAVER MODE", continue to step 2 below.
2. Press "FUNCTION" and "ENERGY SAVER" keys simultaneously first.
3. Wait approximately 10 seconds while the machine writes the closing status onto the Hard Disk Drive
Unit and advances into "ENERGY SAVER MODE".
4. Turn the Power Switch on the Left Side of the machine to the OFF position.
5. Unplug the AC Power Cord. (During a Lightning Storm, to prevent electrocution disconnect the
Telephone Line Cable first before unplugging the AC Power Cord.)
* The specifications are subject to change without notice. Panasonic Communications Co., Ltd. reserves
the right to make improvements in the product design without reservation and without notice.