Panasonic DP-180/190, Service Manual

Page: 161 / 296

161
UF-9000
JAN 2004
Ver. 1.0
DP-180/190
008 Monitor 1 = Off
2 = On Selects whether the Monitor is ON/OFF for
monitoring fax signals.
(FOR SERVICE USE ONLY)
009 DC Loop 1 = Off (Normal)
2 = On (Off Hook) Selects a false Off Hook state for back to back
communication test.
010 TX Level 00 = 0 dBm
~
15 = -15 dBm Selects the TX signal output level, 0 to -15 dBm in 1
dBm steps. (Refer to Chapter 4.3.)
011 RX Level 1 = -43 dBm
2 = -38 dBm
3 = -33 dBm
4 = -48 dBm Selects the receiving sensitivity of -33/-38/-43/-48
dBm.
012 DTMF Level 00 = 0 dBm
~
15 = -15 dBm Selects the DTMF output level, 0 to -15 dBm in 1
dBm steps.
013 G3 RX EQL 1 = 0dB
2 = 4dB
3 = 8dB
4 = 12dB Selects the cable equalizer for G3 reception mode,
0dB, 4dB, 8dB or 12dB.
014 G3 TX EQL 1 = 0dB
2 = 4dB
3 = 8dB
4 = 12dB Selects the cable equalizer for G3 transmission
mode, 0dB, 4dB, 8dB or 12dB.
015 ~
016
Not Used
017 TX Start 2400 bps
4800 bps
7200 bps
9600 bps
TC7200
TC9600
12000 bps
14400 bps Selects the transmission modem start speed,
14400/12000/TC9600/TC7200/9600/7200/4800/
2400 bps.
Press “V” or “/\ “ to select the symbol rate.
Note:
This parameter is applicable only when
communicating with regular G3 machines. When
communicating with Super G3 (V.34) machines,
use Parameter No. 32.
018 RX Start 2400 bps
4800 bps
7200 bps
9600 bps
TC7200
TC9600
12000 bps
14400 bps Selects the reception modem start speed, 14400/
12000/TC9600/TC7200/9600/7200/4800/2400 bps.
Press “V” or “/\ “ to select the symbol rate.
Note:
This parameter is applicable only when
communicating with regular G3 machines. When
communicating with Super G3 (V.34) machines,
use Parameter No. 33.
019 ITU-T V.34 1 = Off
2 = On
3 = Select Selects whether the ITU-T V.34 is Off, On or Select.
Select : Select whether the ITU-T V.34 is Off or On,
when entering Phone Book Dialing
Numbers or Manual Number Dialing.
020 ITU-T ECM 1 = Off (Invalid)
2 = On (Valid) Select the ECM mode.
Function Parameter Table
No. Parameter Selections Function