Panasonic BT-LH910G, Operating Instructions Manual

Page: 37 / 76

37
Main Menu
(continued)
RESET operation
Press [ 1. ][ ] in the “SYSTEM CONFIG”
menu, select the [CALIBRATION] submenu
and press [ENTER].
Press [
2. ][ ], select the [RESET] submenu
and press [ENTER].
MENU EXIT SEL. ENTER ENTER
[RESET]
YES
NO
Select “YES” and press [ENTER]. 3.
This starts calibration.
MENU EXIT SEL. ENTER ENTER
[RESET]
xxxxxxxx
xxxxxxxxx indicates that the following message
with the meaning listed below appears.
COMPLETE: Operation completed
Turn the power off and then on after 4.
performing auto calibration.
VF CONFIG
The underlined values are factory preset setting values.
Sub menu Settings Description
VF CONTROL VF-CH
ALL-CH Used to select the input line for the VF function of the monitor.
(VF function: tally lamps (red and green) lit, zebra displayed,
!
displayed, aspect changed [SD])
<VF-CH> Only enabled when the VF line is selected.
<ALL-CH> Enabled with all input lines.
REAR TALLY OFF
ON Used to allow control of the tally lamp on the rear of the monitor.
<OFF> Does not light.
<ON> Lights when TALLY control from a GPI/camera is ON.
ZEBRA OFF
ON Used to set ZEBRA information in the camera.
<OFF> Sets the information to OFF.
<ON> Sets the information to ON.
The priority sequence for GPI control and SERIAL is as follows: GPI > VF CONFIG > SERIAL. •