15
%4
Pan Reverse Switch [PAN REVERSE, NOR/REV]
Changes the pan direction controlled by PAN/TILT
Lever
#8
. The pan/tilt head turns leftward when
PAN/TILT Lever
#8
is moved toward LEFT, or rightward
if it moved toward RIGHT. The rotary head turns in the
opposite direction if the PAN REVERSE Switch
%4
is in
the REV position, provided that PAN REVERSE Switch
%4
is in the NOR position. When PAN REVERSE
Switch
%4
is set to the REV position, the pan/tilt head
turns in the opposite directions.
With PAN REVERSE Switch
%4
in the REV position, the
operating directions shown on the panel are opposite to
the indications on the panel. In this case, paste the sup-
plied seal on the panel.
Note: TILT REVERSE Switch
%3
and PAN REVERSE
Switch
%4
may be used to reverse the operating
direction of the pan/tilt head, but be sure to set the
operating direction of the pan/tilt head with its
mounting direction selection switch during its instal-
lation depending on whether the pan/tilt head is
mounted on the floor or is suspended.
Unless the mounting direction selection switch on
the pan/tilt head is properly set, the pan/tilt head will
pan or tilt in the opposite direction and the pan/tilt
head operation limiters will not be properly stored in
the memory. For details on the setting of this
switch, refer to INSTALLATION OF PAN/TILT
HEAD.
$9
Speed Switch Changing Switch
[SPEED SW CHANGE, LOW/HIGH]
Changes the polarity of SPEED Switch
@9
. If ZOOM
lever
#6
, FOCUS Lever
#7
, or PAN/TILT Lever
#8
is
moved while keeping SPEED Switch
@9
depressed, the
corresponding operation takes place at low speed, pro-
vided that SPEED SW CHANGE Switch
$9
is in the
LOW position. If one of these levers is moved with
SPEED Switch
@9
depressed when SPEED SW
CHANGE Switch
$9
is in the HIGH position, the corre-
sponding operation takes place at high speed.
The speed polarity can also be changed by pressing
MEMORY Switch
@7
while keeping SPEED Switch
@9
depressed. When this step is taken again, the original
speed polarity is restored. Take this step if it is difficult
to shift SPEED SW CHANGE Switch
$9
because this
control panel is mounted on a console or the like.
%0
Zoom Reverse Switch
[ZOOM REVERSE, NORM/REV]
Changes the operating direction of ZOOM Lever
#6
.
The lens zoom moves toward TELE when ZOOM Lever
#6
is moved toward TELE, or toward WIDE when it is
moved toward WIDE, provided that ZOOM REVERSE
Switch
%0
is in the NOR position. When ZOOM
REVERSE Switch
%0
is set to the REV position, lens
zoom operation takes place in the opposite direction.
With ZOOM REVERSE Switch
%0
in the REV position,
the operating directions shown on the panel are
reversed. In this case, paste the supplied seal on the
panel.
%1
Zoom/Focus Exchange Switch
[ZOOM/FOCUS EXCHANGE, ON/OFF]
ZOOM Lever
#6
and FOCUS Lever
#7
exchange their
function between them when this switch is set to the ON
position. Unless this exchange is needed, keep the
switch in the OFF position.
With ZOOM/FOCUS EXCHANGE Switch
%1
in the ON
position, the operations shown on the panel do not
agree with the indications on the panel. In this case,
paste the supplied seal on the panel.
