910-198E
8/19/03
Page 2-4
Model 8500
3.
Select the target ball that you will be using in subsequent measure-
ments, along with the Red Labelled Alignment Fixture for that ball
size. The fixture centers the target ball on the probe tip. Place the
ball on top of the fixture. Place the fixture over the tip of the probe
and slide it down until it stops, as shown in Figure 2-1.
Note:
Place the target ball into the red labelled fixture before plac-
ing the fixture onto the probe. Dropping the ball repeatedly
into the fixture as it rests on the probe may pit the tip of the
probe causing small measurement inaccuracies.
Figure 2-1: Alignment of Target Ball in Fixture on Probe
Artisan Technology Group - Quality Instrumentation ... Guaranteed | (888) 88-SOURCE | www.artisantg.com
