INSTALLATION INSTRUCTIONS
M-1754 11-21-07
4.
Install the auger drive unit to pendulum mount with pivot pin provided with the drive unit
assembly.
5.
Install the auger to the drive unit with the bolt and nut provided with the drive unit as-
sembly.
6.
Refer to the
“HYDRAULIC SYSTEM HOOK-UP”
section in this manual for hydraulic
connection instructions and recommendations.
BACKHOE AND EXCAVATOR “PIN GRABBER” MOUNTING ASSEMBLIES
1.
Remove the bucket from the dipper arm and curl cylinder pin connections.
2.
Attach the pin grabber mounting (all types) to the dipper and curl cylinder using the pivot
pins and cotter pins provided.
3.
Attach the swivel (#23835) to the pin grabber mounting bracket with pivot pin provided.
Secure the pin in place with safety pin (#10040).
4.
If your mounting bracket is designed for the installation of a cradle, bolt the cradle to the
bracket using the .50” UNC X 2.00” capscrews, lock washers and hex nuts provided.
5.
Install the drive unit to the swivel using the pin provided with the drive unit assembly.
6.
Install the auger to the drive unit with the bolt and nut provided with the drive unit as-
sembly.
7.
Refer to the
“HYDRAULIC SYSTEM HOOK-UP”
section in this manual for hydraulic
connection instructions and recommendations.
WELD-ON EXCAVATOR MOUNTING
McMillen offers a blank weld on plate with mounting ears and swivel for welding onto
your own excavator mounting bracket.
After securely welding the plate onto your bracket:
12
75623