1.
Attach the swivel (#23835) to the mounting plate with pivot pin #23839 provided. Secure
the pin in place with safety pin #10040.
2.
Install the drive unit to the swivel using the pin provided with the drive unit assembly.
3.
Install the auger to the drive unit with the bolt and nut provided with the drive unit as-
sembly.
4.
Refer to the
“HYDRAULIC SYSTEM HOOK-UP”
section in this manual for hydraulic
connection instructions and recommendations.
WARNING! REMOVE PAINT BEFORE WELDING OR HEATING.
Hazardous fumes/dust can be generated when paint is heated by welding,
soldering or using a torch. Do all work outside or in a well ventilated area
and dispose of paint and solvent properly. Remove paint before welding or
heating.
When sanding or grinding paint, avoid breathing the dust. Wear an ap-
proved respirator. If you use solvent or paint stripper, remove stripper with
soap and water before welding. Remove solvent or paint striper containers
and other flammable material from area. Allow fumes to disperse at least 15
minutes before welding or heating.
INSTALLATION INSTRUCTIONS
M-1755 2-18-08
75623
13
