OPERATING INSTRUCTIONS
M-1736 11-15-13-2
9.
If necessary, repeat steps 7 & 8 to obtain a cleaner hole.
10.
In some soil conditions or when excessive down pressure is applied, auger may “screw” itself
into the ground and become stuck causing earth drill to stall. If this happens, reverse the auger
rotation (counter-clockwise) by moving the control valve lever to the reverse position and slowly
raise the auger. Once unstuck, return the control valve lever to the forward rotation position and
continue digging.
11.
If the auger becomes lodged under rocks, roots, or other large obstructions, do not attempt to
raise the auger out of the ground. See step 10 for proper procedure to relieve the auger.
12.
Avoid excessive side loading to earth drill which can cause drive unit or auger damage.
13.
Keep auger teeth and points in good condition. Check frequently and always keep spares on
hand so they can be replaced as wear is detected to avoid damage to tooth holders and auger
flighting.
WARNING: To prevent possible injury or death, keep all bystanders 10 feet or more away from
rotating auger. Take extra precautions when digging in locations where any type
of landscape fabric may be present.
STORAGE
• Check that drive unit motor and hoses are full of clean oil and planetary is full.
• Coat liberally with grease the output shaft and collar, extension shaft and collar, and all connecting
pins to prevent rust and reduce wear.
• Clean the unit thoroughly, removing all mud, dirt, and grease.
• Inspect for visible signs of wear, breakage, or damage. Order any parts required and make the nec-
essary repairs to avoid delays upon removal from storage.
• Tighten loose nuts, capscrews and hydraulic connections.
• Seal hydraulic system from contaminants and secure all hydraulic hoses off the ground to help pre-
vent damage.
• Replace decals that are damaged or in unreadable condition.
• Store unit in a dry and protected place. Leaving the unit outside will materially shorten its life.
Additional Precautions for Long Term Storage:
• Touch up all unpainted surfaces with paint to prevent rust.
REMOVAL FROM STORAGE
• Remove cover.
• Wash unit and replace any damage and/or missing parts .
• Check hydraulic hoses for damage and replace as necessary.
16
75623
