M-2196 2-4-13
EQUIPMENT SAFETY PRECAUTIONS
TRANSPORTING THE AUGER
• Travel only with the earth auger in a safe transport position to prevent uncontrolled
movement. Drive slowly over rough ground and on slopes.
• Tether the earth auger with a chain, if necessary, to prevent uncontrolled swinging of
the auger when moving from hole to hole.
• Do not drive close to ditches, excavations, etc., cave in could result.
• Do not smoke when refueling the prime mover. Allow room in the fuel tank for expan-
sion. Wipe up any spilled fuel. Secure cap tightly when done.
• Remove the earth auger from the prime mover before transporting to and from the job
site.
MAINTAINING
THE
AUGER
• Before performing maintenance, lower the attachment to the ground, apply the parking
brakes, turn off the engine, and remove the key.
• Never adjust a relief valve for pressure higher than recommended by the prime mover
manufacturer.
•
Never perform any work on an attachment unless you are authorized and qualified
to do so. Always read the operator service manual’s before any repair is made. After
completing maintenance or repair, check for correct functioning of the attachment. If
not functioning properly, always tag “DO NOT OPERATE” until all problems are cor-
rected.
• Worn, damaged, or illegible safety decals must be replaced. New safety decals can be
ordered from McMillen
®
free of charge.
• Never make hydraulic repairs while the system is under pressure. Serious personal
injury or death could occur.
75623
9
